↗PISTONS & CONNECTING RODSThe rotating assembly↗LONG-BLOCK ASSEMBLYThe complete foundation↗CYLINDER HEADSAirflow starts here↗ENGINE BLOCKInside the cylinder banks↗MAIN BEARINGSDetails that carry the load
Component photography illustrates the McLaren engine architecture. Final parts are confirmed on your Corsa Motorworks build sheet.
COMPLETE-BUILD COMPARISON
1,200 WHP
Published package benchmark
PISTON / CYLINDER PLANForged pistons & rings
CORE HARDWAREHead & main studs
PREPARATIONAlign-hone & cylinder hone
CORSA MOTORWORKS / STAGE 2
What’s included in Stage 2.
The Corsa Motorworks Stage 2 McLaren engine combines a full mechanical refresh, forged internals and precision assembly in a dressed, sealed long-block configuration.
01
Comprehensive teardown & engine analysis
Complete engine assessment
A full teardown establishes component condition and a report of parts suitable for reuse.
Strip and rebuild
Components are removed, assessed and refitted as part of the mechanical refresh.
Crankshaft preparation
The crankshaft is inspected, cleaned and polished before assembly.
02
Block & rotating assembly machining
Main bore alignment
Align honing establishes the crankshaft and bearing alignment required by the build.
Block cleaning
Hot-tank and steam cleaning prepare the block for machining and assembly.
Cylinder honing
Cylinder surfaces are finished for the selected piston rings.
Matched connecting rods
Rods are weight-matched and pin-fitted for the rotating assembly.
Forged piston package
Forged pistons, performance wrist pins and rings form the Stage 2 piston assembly.
High-strength rods
Corsa Motorworks specifies upgraded rods for the intended operating demands.
03
Hardware & internal components
Head and main studs
Upgraded studs provide the clamping hardware for the Stage 2 assembly.
Multilayer head gaskets
Performance multilayer gaskets are selected for the engine specification.
Performance bearings
King Racing rod bearings and suitable performance main bearings are specified to the required clearances.
Fresh engine seals
Front and rear main seals and the front engine-cover seal are renewed.
Cam-phaser hardware
Updated cam-phaser bolts are included in the timing hardware plan.
04
Head service & final assembly
Cylinder-head service
Heads are cleaned, inspected and rebuilt where inspection identifies a need.
Measured assembly
Bearing clearances and torque sequences are checked throughout assembly.
Dressed and sealed
Your Corsa Motorworks long block is assembled and sealed, ready for the agreed installation scope.
THE CORSA MOTORWORKS APPROACH
Why choose Corsa Motorworks Stage 2?
Stage 2 gives your McLaren a coordinated plan for forged internals, machining and supporting hardware. At Corsa Motorworks, component selection follows your engine condition and driving goals. We review the complete setup with you so the engine, fuel system, turbo package and calibration can be planned together.
Installation & support
Discuss in-house installation with Corsa Motorworks, or shipment of the assembled long block to your chosen technician. Your quote confirms installation or shipping scope, build documentation and support arrangements.
Plan your Stage 2 McLaren build
Contact Corsa Motorworks to discuss your engine condition, intended use, component choices and a tailored quote.
Final components and machining follow inspection of your engine. Turbochargers, fuel-system upgrades, calibration, installation and shipping are quoted separately. Power targets and lead time are agreed with your build sheet.